Whirlpool · Dryers
Whirlpool Dryer PF: Power Failure and Restart Checks
THE SHORT ANSWER
A power interruption stopped the drying cycle.
PF means a power failure interrupted drying. It records an interruption rather than identifying a broken heater.
Confirm whether the home recently lost power.
Do not handle damaged wiring or repeatedly reset a tripping breaker.
WHAT YOU MAY NOTICE
Symptoms to record
- Drying cycle stops.
- PF appears after power returns.
UNDERSTAND THE POSSIBILITIES
Causes & useful observations
A code identifies a condition. It does not, by itself, confirm which part needs repair.
| Possible cause | What to look for | Safe check / next step |
|---|---|---|
| Power interruption | A household outage coincides with the stopped cycle. | Check the timing of the interruption. |
| Startup disturbance | Controls were pressed immediately on power-up. | Allow the startup interval before using controls. |
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
Note whether other appliances also lost power.
What to noteUseful context is retained.
Whirlpool specifies holding START to restart the cycle or pressing POWER to clear PF.
What to noteThe requested control action is registered.
After a recent outage, the cited guidance permits a one-minute breaker power cycle. Monitor normal operation.
What to notePF should not keep returning.
Stop here if: Stop if the breaker trips again.
THE DETAILS MATTER
Scope & troubleshooting notes
Clearing is not a repair
A recurring power fault needs investigation even if the display can be cleared.
YOUR NEXT DECISION
When to stop and get help
If PF returns without a known outage, arrange service.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- PF - Error Code - Dryer
Whirlpool · Manufacturer support · Checked
Power failure; START and POWER controls — Whirlpool dryers using the PF display
- Error Codes in Dryers
Whirlpool · Manufacturer support · Checked
AF, L2 and PF entries — Whirlpool dryers using the listed displays